Skil 3100 manual Use only with 7-1/4 or smaller circular saws, Adjustable Foot for Leveling Bench

c. Once the user sets one leg at the desired height, follow the same steps for the remaining three legs.

Fig. 5

Pin is not

depressed = leg is

not secured in locked position

! WARNING	Use only with 7-1/4” or smaller circular saws.
	Larger size saws may be able to cut thru brackets.

c. The cut channel is 2-3/4” deep and can be used with a maximum 7 -1/4” Circular Saw. The cutting channel can be used for cross cuts or rip cuts. The user must secure the work piece with the wedge dogs provided or other clamping devices (Fig. 8). Do not rip parallel to X-Bench dogs,.

Fig. 8

Direction of

Cut

4. Adjustable Foot – for Leveling Bench

a. If you are working in an area that is not level, we have provided a solution. We have an adjustable foot that will extend 1.75” inches to level your bench (Fig. 6).

Before operating make sure the entire unit is ! WARNING placed on a solid, flat, level surface. Serious

injury could occur if tool is unstable and tips.

Fig. 6

5. Opening the Cut Channel

!WARNING Cut channel must be fully open for sawing.

a. To open your cut channel there are four latches you need to open first.

b.Unlock the four latches by pulling them upward and extend the table outward (Fig. 7).

Fig. 7

Latch is now in the	Latch is now in the
locked position.	open position.

20	21	22	23	24	25	26	27	28	29	30	31	32	33	34	35	36	37	38	39	40	41	42	43	44	45	46	47	48
8			9		10			11		12			13		14			15			16		17			17		18

!Do not use the dog holes to pull the table WARNING outward. Once the table is extended, the

latches MUST be locked in order to use the cut channel correctly. Failure to lock the latches while the table is in the open position could cause the table top to move while cutting, which can result in misaligned cuts or personal injury.

6. Wedge Dogs

a. Dog holes are throughout the table top surface and are meant to hold work pieces in place while cutting (Fig. 9). Two wedge dogs come with the X-Bench. These dogs are made specifically for the X-Bench. Note feed direction while cutting in wedge dog position. Blank insert plate must be in table top during top applications. See reference guide figure 28 for hole pattern identification of wedge dogs.

Fig. 9

Direction of

Cut

7. Miter Saw Mounting

a. There are three mounting holes that support most miter saw dimensions (Fig. 10). If you use a miter saw on this table, we require you mount the miter saw to the X-Bench for safety. Note: close cut channel for miter saw use.

Fig. 10

6.