![](/images/new-backgrounds/1260690/2606905x1.webp)
INSTALLATION INSTRUCTIONS
(READ ALL INSTRUCTIONS BEFORE PROCEEDING!)
Dock Edge Construction
The procedure for the installation of the
Failure to follow the proper installation procedure will decrease capacity of dockleveler.
Recommended dock edge for new construction
The recommended dock edge for new construction is a well anchored 6 inch channel (8.2 lb. minimum). Concrete "J" anchors shall be 1½ inches wide with a length of 6 inches plus 1½ inches bent at 90 degrees on the end. Minimum material
6" Channel thickness shall be ¼ inch. One anchor shall be installed every 12 inches.
Height Differential
The optimum dock height in most cases is 50". On dock heights significantly different than 50", ramps and ramp support angles as shown below must be employed.
Ramp Plate | Ramp Plate |
96"W x 12"L x 2"H | 96"W x 24"L x 4"H |
E N G L I S H
48" High Dock
Linkage Installation Instructions
FOR MECHANICAL
1.) Remove the cotter pin from the clevis pin.
2.) Remove the clevis pin from the linkage arms.
3.) Move the lip plate down until the hole in the mounting bracket is aligned with the holes in the link arms.
4.) Insert the clevis pin through the aligned holes and fasten with the cotter pin.
46" High Dock
LINK
ARMS
COTTER PIN
MOUNTING
BRACKET
CLEVIS PIN
3