4.CHANGE THE OPERATION CODE FOR BOTH TRANSMITTER AND RECEIVER (CONT)
3If the connector is placed on the top and middle posts, that column is set on “ + ” . If the connector is placed on the middle and bottom posts, that column is set on “ - ”. If the connector is
removed completely, (not placed on any posts), it is set to “ 0 ”.
(see diagram for examples of how to | ‘0’ |
set a column to the three different | |
positions). When removing a con- | ‘+’ |
nector to set a column to “ 0 ”, save | |
the connector in case you change | |
the code at a later date. |
|
4After setting up the code connectors on the transmitter, you are ready to set the same code on the receiver.
| Remove the receiver from the electrical outlet before |
WARNING | changing the code. |
|
5 Remove the screw that holds the connector cover, and remove the cover.
6You will see 10 connectors. For connectors “1” to “9”, the settings must match with those of the transmitter.
Connectors |
|
1 to 9 are |
|
the same. | BATTERY |
|
7For connector “10” on the receiver, set the connector on “+” if you are using button “1” to control this receiver. If you are planning to use button “2” to control this receiver, you need to remove this connector. See diagram below.
Connector 10 set to “+” | TRANSMITTER |
| Button 1- Left Button |
RECEIVER
Connector 10 “Removed” | TRANSMITTER |
| Button 2- Right button |
RECEIVER
8Put the cover and screw back onto the receiver. Plug the receiver into an electrical outlet.
9Put the battery cover back onto the transmitter.
10 Press the designated button on the transmitter to operate the garage door.
5. BATTERY
12 volt alkaline battery (size 23A) (included).
It is time to change the battery when the red LED on the trans- mitter does not turn on when either button is pressed.
6. ADDITIONAL RECEIVER
There are 2 buttons on your transmitter, the other button can be used to control another Houselink® Garage Door Receiver Model 318R (sold separately) or Houselink® Wireless Switch Receiver Model
7. ADDITIONAL TRANSMITTER
You can add as many additional transmitters as you want to control the same receiver. Simply set the same operation code on all transmitters with the same code setting on the receiver. Houselink® offers Keychain Transmitter Model 318TN and Keyless Entry Transmitter Model 318K to work with your receiver. For more information, please visit our website at www.skylinkhome.com or contact us.
8. CAUTION
RISK OF ELECTRICAL SHOCK. FOR INDOOR USE ONLY. CAUTION : DISCONNECT POWER BEFORE CODE CHANGING. REPLACE COVER AFTER CODE CHANGING.
Maximum Rating:
Input : 120VAC 60Hz 2W
9. FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferencetoradioortelevisionreception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
10. WARRANTY
If, within one year from date of purchase, this product should become defective (except battery), due to faulty workmanship or materials, it will be repaired or replaced, without charge. Proof of purchase and a Return Authorization are required.
11. CUSTOMER SERVICE
If you would like to order Skylink’s products or have difficulty getting them to work, please :
1.visit our FAQ website at www.skylinkhome.com, or
2.email us at support@skylinkhome.com (reply within 24 hrs), or
3.call our toll free at
CUSTOMER SERVICE
Email:support@skylinkhome.com (Reply within 24 hrs)
http://www.skylinkhome.com
P/N.
US Patent. D380895
©2003 SKYLINK GROUP