–8–INSTALLATION
3. Thread the AC adapter cord through the top
hole in the back of the unit and plug it into
the AC connector on the circuit board as
shown. The adapter cord must be inserted
through the back of the unit beforeit is
attached to the wall.
4. Insert the 9 volt battery and rotate the
antenna from the inside of the dialer tothe
outside.
5. Firmly close the case. Insert and secure the
two screws to the bottom case near the two
tabs.
6. Using the template provided, insert the two
screws into the wall.
7. Gently hang the Dial-Alert to these two
screws.
8. Plug the other end of the telephone cord into
a telephone jack. Plug the AC adapter into a
power outlet. The red AC PWR light will turn
on and the keypad backlight will be on.
NOTE: After installation, please use two screws
(included) to fix the front and back case together
before hanging on to the wall. (When you open
the case, please remove the AC adapter
and the phone line from the wall outlet).
2. Thread the telephone line through the top
hole in the back of the unit and plug it into
the "LINE" jack. If you want to have an
answering machine on the same line as
the dialer, thread the phone line through the
bottom hole in the back of the unit and plug
it into the "PHONE" jack of the dialer. The
phone line(s) must be inserted through
the back of the unit before it is attached
to the wall.
–9–INSTALLATION
Speaker On/Off Switch
The speaker must be on during pro-
gramming and recording the voice
message in order to use the playback
feature. For security purposes, the
speaker may be turned off after pro-
gramming to allow for silent dialing
when the dialer is activated.
The On/Off switch for the speaker is
located on the lower right corner of the
circuit board. The default setting for the
speaker is "On".