| Introduction |
| Programming the transmitter and the Silent Alarm |
|
| ||
|
|
|
|
| Warranty |
| FCC |
|
| ||
|
|
|
|
The Silent Alarm
transmit a signal to the Silent Alarm, and the appliance that has been plugged into the silent alarm will be turned on and off for approximately 15 seconds. If a lamp is plugged into the Silent Alarm, the light will flash so that it can notify the hearing impaired. (or you may plug in a radio to warn the visually impaired)
1.In order for the Silent Alarm to recognize different transmitters, they must first be“learned” to the Silent Alarm.
2.Plug in the Silent Alarm to an electrical outlet (its red LED light wi ll go on). Plug in an appliance (i.e. light, radio, maximum 1200 watts) to the outlet of the Silent Alarm.
3.Turn on the appliance that is plugged into the Silent Alarm. Turn on the Silent Alarm by pressing the “ON/OFF” button. The appliance should be on after the “ON/OFF” button is pressed. If you press the “ON/OFF” button again, the appliance will be turned off.
4.With the Silent Alarm plugged in, press and hold the “SET” button on the unit (its red LED light will flash). Simultaneously activate the sensor that you want to program to the silent alarm until the red LED light on the silent alarm stops flashing indicating it has learned the code.
5.Test the sensor by activating it while the Silent Alarm and the appliance are plugged in. The appliance will turn on and off for approximately 15 seconds. If the appliance that you plugged in does not turn on and off, repeat the above procedures .
If, within one year from date The Remote Control is
of purchase, this product | approved by the FCC and |
should become defective, | it complies with Part 15 |
due to faulty workmanship | of the FCC Rules. Its |
or materials, it will be re- | operation is subject to the |
paired or replaced, without | following two conditions : |
charge. Proof of purchase | 1. This device may not |
is required. | cause harmful inter- |
| ference. |
| 2. This device must accept |
| any interference that |
| may cause undesired |
| operation. |
WARNING:
Changes or modifications to this unit not expressly approved by the party res- ponsible of compliance could void the user’s authority to operate the equipment.
NOTE
I f you would like to order Skylink’s product or have difficulty getting them to work, please :
1.visit our website FAQ section at www.skylinkhome.com , or
2.email us at support@skylinkhome.com , or
3.call our toll free at
fax:
Skylink will not be held liable or responsible for any misuse or application of this product other than for its intended use.
CUSTOMER SERVICE
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3 Email:support@skylinkhome.com http://www.skylinkhome.com P/N.
US Patent 6243000B1 ©2005 SKYLINK GROUP
| ® |
| |||
|
| SILENT ALARM | |||
their | USER'S INSTRUCTIONS | ||||
| (Model | ||||
® are registered trademarks of | respective corporations |
|
|
|
|
|
|
|
| ||
| |||||
|