SkyLink TB-318 manual Introduction Installation, Programming Transmitter to Receiver Module

Wall Mount Transmitter Model TB-318

1. INTRODUCTION

3. INSTALLATION

Thank you for your purchase of a SkylinkHomeTM Wall Mount Transmitter, Model TB-318. This transmitter allows you to wirelessly operate lighting / home automation with the SkylinkHomeTM receiver modules.

All wireless signal communications within the SkylinkHomeTM System are based on rolling code technology to ensure highest security is used.

You will find the following in this package:

-Wall Mount Transmitter

-Mounting Accessories & Double-sided Foam Tape

-Lithium Battery CR-2032

-User's Instructions

After programming, you are now ready to install the Wall Mount Transmitter .

You may use double sided foam tape to stick the transmitter on the wall, or you may use screws to mount the transmitter.

Using double sided foam tape:

Place the 2 double sided foam tapes on the back of the back plate. Clean the surface of the wall where you plan to install the back plate. Peel off the foam tape cover and stick it to the wall surface.

Tighten

2 screws

Place double-sided foam tape

Using screws:

Wall Mount

Lithium battery

Double-sided

Foam Tape

Screws and anchors

If you are using screws, tighten the back plate of the wall mount trans- mitter by the 2 screws provided. If you are installing the back plate to an existing wall switch with wall box, no need to use the anchors. Other- wise, drill 2 small pilot holes based on the 2 mounting screw positions and insert the anchors before tightening the back plate with screws.

After securing the back plate, either by double sided foam tape or screws, tighten the 2 screws on the front to secure the front plate.

Transmitter

2. PROGRAMMING TRANSMITTER TO RECEIVER MODULE

In order to operate a receiver module remotely, a transmitter must be programmed to the receiver module.

To program a transmitter into the receiver module, follow the instructions below.

1. Remove the front wall plate from the Wall Mount

Transmitter by loosening the 2 screws.	Loosen up
	2 screws

2. Insert the battery to the Wall Mount Transmitter as shown. Positive side up. When the battery is installed, the red LED on the transmitter will be on for 1 second.

Existing Gang Box	Drill 2 pilot holes
(No Anchor)	& insert anchors

4. ON / OFF OPERATION

Pushing the pad from one position to the other will toggle the status of a load, i.e. when the light is off, pushing the pad will turn on the light, and vice versa.

	Push
Slide in	Down
2	20 32
+	+

Push pad to

Push

toggle on / off

Push

Toggle on / off

5. BRIGHTNESS CONTROL OPERATION

Besides turning on and off a load, you may also control the brightness of a light if the receiver module and the light bulb is dimmable, i.e. either incandescent light or dimmable compact fluorescent light.

To change the brightness, first turn on the light by pushing the pad.

3.You may transmit the programming signal from the transmitter by pressing the “SET” button on the transmitter. The red LED on the transmitter will be on for 15 seconds.

4.Put the receiver module that you plan to program into programming mode. Refer to the User's Instructions of that receiver module.

5.Activate the Wall Mount Transmitter by pressing the pad on the front. Its red LED will flash then off.

6.Once the transmitter is programmed, the receiver module will quit from programming mode.

7.Now the programmed transmitter is ready to be used.

Battery

(Positive side up)

SET

Button

CR 2032

+

Red

LED

Pad

Then, press and hold the pad after the light is on will change the brightness of the light. When the desired brightness is reached, release the pad.

Press and hold the pad again to change the brightness in the opposite way. When the desired brightness is reached, release the pad.

Press and Hold

OR

Press and Hold

Brightness Control