Extron electronic RAC 104 user manual Installation and Operation, cont’d, Furniture mounting

Installation and Operation, cont’d

Furniture mounting

Furniture mount the RAC 104 using the optional MBU 123 mounting kit (Extron part #70-212-01) as follows:

1.	Remove rubber feet if they were previously installed on
	the bottom of the RAC 104.
2.	Attach the furniture mounting brackets to the RAC 104
	with the machine screws provided.
3.	Hold the RAC 104 with the attached brackets against the
	underside of the table or other furniture. Mark the
	location of the screw holes of the bracket on the mounting
	surface.
4.	Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
	deep in the mounting surface at the marked screw
	locations.
5.	Insert #8 wood screws into the four pilot holes. Tighten
	each screw into the mounting surface until just less than
	1/4" of the screw protrudes.
6.	Align the mounting screws with the slots in the brackets
	and place the RAC 104 against the surface, with the screws
	through the bracket slots. See the illustration below.

7.Slide the RAC 104 slightly forward or back, then tighten all four screws to secure the unit in place.

A

2	AUDIO	CONTROLS
1	B
		4	ADJUSTM
		3		Vol. ENTS
		VOL		Ba
			UME	eble
				&TO
				NE C
				ONT
				ROLLER

Mounting the RAC 104 under furniture

2-4 RAC 104 • Installation and Operation