B.BEFORE OPERATING smell all around the appli- ance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•DO NOT try to light any appliance.
•DO NOT touch any electric switch; DO NOT use any phone in your building.
•Immediately call your gas supplier from a neigh- bor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. NEVER use tools. If the knob will not push in or turn by hand, DON’T try to repair it, call a quali- fied service technician. Force or attempted repair may result in a fire or explosion.
D.DO NOT use this appliance if any part has been underwater. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been underwater.
LIGHTING INSTRUCTIONS
1.STOP! Read the safety information on page 7 and above.
2.Set the thermostat to lowest setting.
3.Turn off all electrical power to the appliance.
4.Remove control access panel. (Galaxy models only.)
5.Turn gas control knob clockwise 
to “OFF”.
6.Wait five (5) minutes (longer for propane) to clear out any gas, then smell for gas, including near the floor. If you then smell gas STOP! Follow “B” in the safety information above on this page, if you don’t smell gas, go to next step.
7.Remove the pilot access panel located below and behind the gas control unit.
8.Find pilot, follow metal tube from gas control. The pilot is between two burner tubes behind the pilot access panel.
9.Turn knob on gas control counterclockwise to “PILOT”.
10.Push in red button all the way and hold in. Immediately light the pilot with a match. Continue to hold the red button in for about one (1) minute after the pilot is lit. Release button and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 5 through 10.
•If button does not pop up when released, stop and immediately call your service technician or gas supplier.
•If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.
11.Replace pilot access panel.
12. Turn gas control knob counterclockwise |
| to |
| ||
“ON”. |
|
|
|
|
13.Replace control access panel. (Galaxy models only.)
14.Turn on all electric power to the appliance.
15.Set thermostat to desired setting.
TO TURN OFF GAS TO APPLIANCE
1.Set the thermostat to lowest setting.
2.Turn off all electric power to the appliance, if service is to be performed.
3.Remove control access panel. (Galaxy models only.)
4. Turn gas control knob clockwise |
| to “OFF”. DO |
| ||
NOT force. |
|
|
|
|
5.Replace control access panel. (Galaxy models only.)
These boilers are equipped with both a blocked vent safety switch and a rollout safety switch. The blocked vent safety switch is located on the draft hood flue stack. This is a manual reset control used to prevent excessive spillage of flue gases from the draft hood. The rollout safety switch is a single use (one time) thermal fuse to prevent the boiler from operation if flue passages are blocked. If either of these devices operate to shut down the burners, follow instructions in the section “To Turn Off Gas To Appliance” and call your service technician or gas supplier.
Your gas boiler must be installed and serviced by a qualified service agency or gas supplier. The lack of proper service can result in a dangerous condition.
©Slant/Fin Corp. 2004.
SLANT/FIN CORPORATION, Greenvale, N.Y. 11548 • Phone: (516)
FAX: (516)
www.slantfin.com
