Slant/Fin operating instructions HOT WATER MODELS VSPH-60 THROUGH VSPH-180, Victory Vsph

™

VICTORY VSPH

®

This manual must be left with owner and should be hung on or adjacent to the boiler for reference.

DIRECT-VENT SEALED COMBUSTION BOILERS

HOT WATER MODELS VSPH-60 THROUGH VSPH-180

GAS-FIRED CAST-IRON BOILERS FOR NATURAL AND L.P. PROPANE GASES

INSTALLATION AND OPERATING INSTRUCTIONS

TABLE OF CONTENTS
Dimensions, Rating and Orifice Sizes	2
Identification of Parts	3
Installation Requirements	4
Venting Application	5
Boiler Room Air Supply and Ventilation	5
Flue gas Venting Requirements	5
Vent Material	5
Air Intake Material	6
Flue and Air Intake Restrictions	6
Non-Direct Vent Installation	8
Sidewall Venting, Non-Direct Vent	8
Vent Termination Location and Clearance	8
Non-Direct Vent Vertical Venting	8
Direct Vent Installation	8
Sidewall Venting, Direct Vent	8
Vent/Air Intake Termination Installation	8
Direct Vent, Venting and Air Intake through a Roof	13
Venting and Air Intake Regular Inspection	15
Gas Piping	15
Electrical Wiring	15
Multi Zoning	18
Water Piping	18
Wiring Diagram	16
Operating Instructions	19
Gas Input Rate Adjustment	20
Boiler Control	22
Sequence of Operation	21
Status of Indicator Lights (LED’s)	22
Safety Check	23
Care and Maintenance	24
General Troubleshooting Guide	25-27

WARNING

The venting system of this boiler is under positive pres- sure. Leakage from this system can be hazardous and if not avoided can result in death or serious injury. In addi- tion to the recommendations within this manual and the User’s Information Manual, the venting system, from the blower to the outdoor discharge, must be carefully checked annually by a qualified service agency.

IMPORTANT

READ ALL OF THE FOLLOWING WARNINGS AND STATEMENTS BEFORE READING THE INSTALLATION INSTRUCTIONS

WARNING

LIQUEFIED PETROLEUM (L.P.)

PROPANE GAS-FIRED BOILERS

Installation location ONLY as permitted in paragraph entitled "LIQUEFIED PETROLEUM (L.P.) PROPANE GAS-FIRED BOILER LOCATION" on page 4 of this instruction book.

The above warning does not apply to NATURAL gas- fired boilers.

The installation must conform to the requirements of the authority having jurisdiction or, in the absence of such requirements, to the National Fuel Gas Code, ANSI Z223.1-latest edition. The installation must also conform to the additional requirements in this Slant/Fin Instruction Book.

In addition where required by the authority having juris- diction, the installation must conform to American Society of Mechanical Engineers Safety Code for Controls and Safety Devices for Automatically Fired Boilers, No. CSD-1.

WARNING

This boiler, gas piping and accessories must be installed, connected, serviced and repaired by a trained, experienced service technician, familiar with all precautions required for gas-fired equipment and licensed or otherwise qualified, in compliance with the authority having jurisdiction.

Heating Contractor

Boiler Model Number

Address

Boiler Serial Number

Phone Number

Installation Date

Printed in U.S.A. 207 Part No. 455035 Publication No. VSPH-40 Rev. A