Smart Technologies 9.5 To create the silent removal file, To remove SMART Board software 7.x

6Silent Removal of Earlier SMART Board Software Versions
You only need to create the initial setup.iss file once. You can then use this setup.iss file to
remove the same version of SMART Board software from other computers on your network.
1. Check the version of SMART Board software that are installed on your computers. Refer to the
table above to identify the GUID you must use in the following commands.
2. Click Start > Run and type CMD into the Open field.
A DOS window opens.
3. Type:
RunDll32 C:\PROGRA~1\COMMON~1\INSTAL~1\PROFES~1\RunTime\0701\Intel32
\Ctor.dll,LaunchSetup "C:\Program Files\InstallShield Installation
Information\GUID\setup.exe" /r -l0x9 --AddRemove
and click OK.
This command removes SMART Board software and creates a setup.iss file in the root of the
Windows folder.
4. Place the setup.iss file on a network server where all computers can access it.
1. Go to each computer and click Start > Run and type CMD into the Open field.
A DOS window opens.
2. Type:
RunDll32 C:\PROGRA~1\COMMON~1\INSTAL~1\PROFES~1\RunTime\0701\Intel32
\Ctor.dll,LaunchSetup "C:\Program Files\InstallShield Installation
Information\GUID\setup.exe" /s -l0x9 --AddRemove /f1"path to the
setup.iss file\setup.iss" /f2"destination path for the uninstall log
file\setup.log"
and click OK.
To create the silent removal file
To remove SMART Board software 7.x