SMC Networks SMC7404WBRA manual Hardware Description

HARDWARE DESCRIPTION

Hardware Description

The Barricade contains an integrated DSL modem and connects to the Internet or to a remote site using its RJ-11 WAN port. It connects directly to your PC or to a local area network using any of the four RJ-45 Fast Ethernet LAN ports or via a wireless network adapter.

Access speed to the Internet depends on your service type. Full-rate ADSL provides up to 8 Mbps downstream and 640 Kbps upstream. G.lite (or splitterless) ADSL provides up to 1.5 Mbps downstream and 512 Kbps upstream. However, you should note that the actual rate provided by specific service providers may vary dramatically from these upper limits.

Data passing between devices connected to your local area network can run at up to 100 Mbps over the Fast Ethernet ports and 11 Mbps over the built-in wireless network adapter.

The Barricade includes an LED display on the front panel for system power and port indications that simplifies installation and network troubleshooting. It also provides the following ports on the rear panel:

Item	Description
LAN	Fast Ethernet ports (RJ-45). Connect devices on your local area
Ports	network to these ports (i.e., a PC, hub, or switch).
Parallel	One parallel printer port that can be connected to a printer. This
printer	printer can then be shared by all LAN users.
port
Reset	Use this button to reset the power and restore the default factory
Button	settings. To reset without losing configuration settings, see “Reset”
	on page 4-59.
Power	Connect the included power adapter to this inlet.
Inlet	Warning: Using the wrong type of power adapter may cause
	damage.
WAN	WAN port (RJ-11). Connect your DSL line to this port.
Port

2-3