Installing the Switch | SMC Networks SMCGS24 guide

INSTALLING THE SWITCH

Note: If an attached device does not support auto-negotiation, the data rate will be sensed automatically and the communication mode will default to half duplex.

4.Cascading Switches and Other Network Devices: All the ports on the switch support automatic MDI/MDI-X configuration for cable connections. This allows you to use straight-through cable to connect to other switches or hubs from any port on the switch. No crossover cables or other device settings are needed. See the “Cable Specifications” on page 9 of this guide for further information.

Caution: Do not plug a phone jack connector into any RJ-45 port. This may damage the switch. Instead, use only twisted-pair cables with RJ-45 connectors that conform with FCC standards.

6

Image 24

SMC Networks SMCGS24 manual Installing the Switch

Contents

Page Page EZ Switch 10/100/1000 User Guide Trademarks Limited Warranty Limited Warranty Compliances FCC Class aEC Conformance Declaration Class a Industry Canada Class a Japan Vcci Class a Compliances Power Cord Set Vii Viii Halten Environmental Statement PurposeAudience Safety Compliance Warnhinweis Faseroptikanschlüsse Optische Sicherheit Xii Table of Contents Viii Features and Benefits Introduction Front Panel RJ-45 Ports Front Panel LEDs Rear Panel Installing the Switch Package ContentsSelecting a Site Instructions Installing the Switch Application Example Typical application for the SMCGS16 is illustrated below Troubleshooting Diagnosing Switch IndicatorsSymptom Possible Solutions Cable Specifications Cables10BASE-T/100BASE-TX Pin Assignments Pin MDI-X Signal Name MDI Signal Name 1000BASE-T Pin Assignments Cable Testing for Existing Category 5 Cable Adjusting Existing Category 5 Cabling1000BASE-T Cable Requirements Product Specifications EZ Switch 10/100/1000 Weight Power ConsumptionPower Requirement Temperature Product Specifications Page For Technical SUPPORT, Call