SMC Networks SMCWMR-AG manual English, Configuration for Wired Operation

English

c)[Encryption enabled?]: Select [Off] if you are not using encryption on your wireless network and go to Step 4e. Select [Hex Digits] to enter your appropriate encryption key.

d)If you selected [Hex Digits] in Step 4c, you will be asked to input the WEP key of your wireless network. Use the Up/Down arrows on your Remote Control to choose the appropriate letters. Use the Left/Right arrows to skip to the next letter of the SSID. Press [OK] on your Remote Control when finished.

e)[Network Type]: Select [Infrastructure] if you are using an Access Point or a Wireless Router to connect your SMCWMR-AG to your wireless network. Select [Peer to Peer] if you have an Ad-hoc wireless network.

f)[DHCP server present?]: Select [Yes] if you have a DHCP server on your network that will allow the SMCWMR-AG to obtain an IP address automatically. If you do not have a DHCP server on your network, select [No] and input your IP, Subnet Mask, and Gateway addresses.

g)[Is proxy present?]: Select [No] and press [OK] on your

remote to continue. (Note: The majority of home networks use a standard Broadband Router to share internet access. In this configuration, there is no proxy present.) Some corporate networks may have proxies in place for advanced security. To configure this setting, simply obtain the proxy IP address and port from your Network Administrator and then input this data via your Remote Control.

h)You have now completed the initial configuration.

You will be asked to confirm the changes by pressing [OK] to continue. The SMCWMR-AG will reset and automatically connect to your network upon boot-up.

i)Once the SMCWMR-AG is connected, it will ask you to [Register Now]. This will give you the option to upgrade your firmware via Smart Box Management to take advantage of new updates. (Note: You can register at any point by going to the [Settings] menu.)

Configuration for Wired Operation

Note: You will need your SMCWMR-AG Universal Wireless Multimedia Receiver Remote Control if you wish to make changes to the default settings.

Step 1: Turn on the SMCWMR-AG. By default, the SMCWMR-AG Universal Wireless Multimedia Receiver will be configured to connect to your SMC2804WBR Barricade g 2.4GHz 54Mbps Wireless Broadband Router and SMC2304WBR-AG EZ-Stream Universal Wireless Broadband Router. The default settings are as follows:

•SSID: [SMC]

•WEP: [Disabled]

•Internet Proxy: [Disabled]

•IP Address: 192.168.2.45 (DHCP Disabled)

•Mode: [Infrastructure]

Step 2: If your network is not configured as specified in Step 1, you will need to configure the SMCWMR-AG to properly establish a connection to your wired network.

Step 3: The SMCWMR-AG will automatically ask you to reconfigure your settings if it was not able to get connected with the default settings.

Step 4: Please answer the on-screen questions to complete the setup.

a)[Network Interface]: Select [Use Wired (Ethernet)] to use a wired network. Remember, to make a selection, press the [OK] button on your remote control.

b)[DHCP server present?]: Select [Yes] if you have

a DHCP server on your network that will allow the SMCWMR-AG to obtain an IP address automatically. If you do not have a DHCP server on your network, select [No] and input your IP, Subnet Mask, and Gateway addresses.

English

13 14