Strictly switch the appliance off prior

 

 

 

 

 

 

cleaning (unplug the power cord from the

 

 

 

 

 

 

wall socket, or turn the selector jog to the

 

 

 

 

 

 

position “0”).

 

 

 

 

 

Clean the casing and drum interior with soft cloth

 

 

 

 

 

and mild detergent.

 

 

Periodically clean (vacuum) the interior of air

 

Cleaning of evacuation

 

drier

 

evacuation opening and evacuation tube.

 

 

 

Water condensation device should be cleaned

 

Cleaning the water

 

 

condensation device

 

three to four times a year, in case of very frequent

 

 

 

 

 

use even more often.

 

 

 

 

 

During cleaning a certain amount of water may

 

 

 

 

 

drip out so it is good to put an absorbing cloth

 

 

 

 

 

below the opening.

 

 

 

 

Open the exterior lid of the condenser by grabbing

 

 

 

 

 

 

 

 

 

 

 

 

 

the handle on the lower left part of the appliance

 

 

 

 

 

housing and pull it downwards.

 

 

 

 

Remove the interior lid by first turning the lever

 

 

 

 

 

vertically down, then tilt the lid towards yourself

 

 

 

 

 

and remove it.

 

 

 

 

Turn the lock on the condenser upwards and pull

 

 

 

 

 

the condenser out by pulling the lever.

 

 

 

 

Clean the device from both sides with lukewarm

 

 

 

 

 

water and drain it well.

 

 

 

 

Before replacing it into its slot, clean the air

 

 

 

 

 

channel in which the device is mounted, and the

 

 

 

 

 

gasket at the interior lid.

 

 

 

 

Lock the condenser into its place.

 

 

 

 

Insert the inner lid to seal well and lock it with a

 

 

 

 

 

handle.

 

 

 

 

Push the exterior lid towards the appliance to lock

 

 

 

 

 

to its place.

 

 

 

 

129316

 

 

 

 

 

 

 

 

 

 

 

 

17

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 17
Image 17
Smeg 129316 manual Cleaning of evacuation, Drier, Cleaning the water Condensation device