Drying procedure

Press the START/PAUSE button (D) - LED E is

 

 

 

 

 

 

on, appliance starts to operate (after a 2 second

 

 

 

 

 

 

pause).

 

 

 

 

 

10 minutes prior the end of drying program the

 

 

 

 

 

 

machine starts the cooling cycle (heater is off),

 

 

 

 

 

 

which prevents excessive creasing.

 

 

 

 

 

At the end of the cooling program the appliance

 

 

 

 

 

 

switches on the anti-crease program, which lasts

 

 

 

 

 

 

for 1 hour (periodic tumbling of the drum); LED (E)

 

 

 

 

 

 

is flashing.

 

 

 

 

 

If you open the dryer door the anti-crease

 

 

 

 

 

 

program is suspended.

 

 

 

 

 

- End of drying

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

At the end of drying LED (E) flashes,

 

 

 

 

 

 

which means that the drying program

 

 

 

 

 

 

 

 

 

 

 

 

is completed. LED (F) is on, which for

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

the evacuation type of dryer requires

 

 

 

 

 

 

cleaning of filter, and for the condensation

 

 

 

 

 

 

type cleaning the filter and draining the

 

 

 

 

 

 

container.

 

 

 

 

 

Open the dryer door by pushing the left-hand side

 

 

 

 

 

 

of the door towards the appliance.

 

 

 

 

 

Remove the laundry from the dryer.

 

 

 

 

 

Turn the appliance off by turning the jog selector

 

 

 

 

 

 

(A) to the position “0”.

 

 

 

 

 

Clean the lint filter (see chapter on Cleaning and

 

 

 

 

 

 

Maintenance).

 

 

 

 

 

Close the dryer door.

 

 

 

 

 

Empty the water container (this applies for

 

 

 

 

 

 

condensation dryers only - see Cleaning and

 

 

 

 

 

 

Maintenance) and replace it back to its slot.

 

 

 

 

 

Pull the power lead from the socket, disconnecting

 

 

 

 

 

 

the appliance from the mains.

129316

12

Page 12
Image 12
Smeg 129316 manual Drying procedure