Cleaning the Spray Arm & Filter plate
Ensure the DishDrawer® is cool before you start cleaning and follow the instructions for removing the drain filter and spray arm.
1Remove the basket carefully. Lift from the back end first to prevent knocking the detergent and rinse agent dispenser.
2Lift the spray arm and shake any foreign material out.
Rinse the spray arm under clean running water and wipe the with a damp cloth.
3In the center of the filter plate there are two rings. Hold the center ring still and turn the outer ring
4Lift the filter plate out.
When cleaning the underside of the filter plate, take care handling the sharp outer edge to avoid the risk of cuts.
Remove any foreign material, wash in hot soapy water and rinse thoroughly in clean water. The heater plate can be wiped with a damp cloth.
5Replace the filter plate so it lies flat in the base of the drawer ensuring the filter plate is fully locked into position with the center ring.
6To lock the filter plate into position, ensure the lines align with each other (refer to the diagram for the correct position). The filter plate must not be able to move about freely.
7Replace the spray arm back onto the impeller.
8Replace the basket, lowering the front edge of the basket into position first.
a
b
c
d
Correct Locking Position of Filter Plate with Motor Assembly (under Spray Arm)
aOuter Ring
bImpeller
cCorrect Alignment marks
dCenter Ring
Note
Where there is broken crockery or glass in the drawer, it must be carefully removed to prevent damage to the DishDrawer®.
24
