Problem | Possible Cause | What to do |
Foaming | Incorrect amount of | Refer to the detergent section or |
| detergent. | consult the detergent manufacturer’s |
|
| instructions. |
|
|
|
| Too much egg in the wash | Increase the amount of detergent. |
| load. |
|
|
|
|
| Rinse agent setting too | Decrease the rinse agent setting. |
| high. |
|
No detergent | Detergent was wet when | Clean the dispenser and ensure the |
dispensed | loaded. | dispenser is dry when adding detergent. |
Excessive motor | The filter plate and/or spray | Refer to the user maintenance section |
noise | arm is incorrectly placed. | for details on correct placement. |
|
|
|
| No water in the motor area. | This usually occurs on the first use or |
|
| when the DishDrawer® has not been |
|
| used for long periods of time. Run the |
|
| DishDrawer® through a wash program. |
|
|
|
Water leaking | Drain hose disconnected | Reconnect the drain hose to the waste |
| from waste pipe. | pipe. |
|
|
|
| Supply inlet hose not | Ensure the inlet hose is connected |
| properly connected. | securely. |
|
|
|
| Other leaks. | Turn water and power supplies to the |
|
| DishDrawer® off. Call your dealer or |
|
| Authorized Service Agent. |
DishDrawer® will Childlock function is on or
not open the Closed Drawer option is on, or both.
Turn the Lock function off. Hold down the / button until thesymbol disappears from the LCD or the light above the / button disappears and/or press the button to open the DishDrawer®.
27