Manuals / Smeg / Kitchen Appliance / Cooktop

Smeg A41C-5 manual Instructions for the installer, Installation Of The Appliance, Levelling

Models: A41C-5

1 26

Download 26 pages 3.57 Kb

Page 4

Instructions for the installer

Instructions for the installer

2. INSTALLATION OF THE APPLIANCE

This unit is equipped with a type Y fire protection, and may be set against walls that are higher than the hob.

The manufacturer declines all responsibility for damage to persons or things caused by non-observance of the above prescriptions or by interference with any part of the appliance.

2.1 Levelling

Adjust the four feet so as to set the appliance on a perfectly level plane. For this purpose, loosen the lock nut and unscrew the foot. The range of adjustment of the screw is 10 mm.

2.2 Electrical connection

Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

On the power line, install an omnipolar cut-off device with contact cut-off distance greater than or equal to 3 mm, located in an easily accessible position near the unit.

The appliance is fitted with a terminal board at the rear for electrical connections (see following diagram). To access, remove the rear cover

32

Image 4

Smeg A41C-5 manual Instructions for the installer, Installation Of The Appliance, Levelling, Electrical connection

Contents

Contents Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USETHE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER USE NEVER UNPLUG BY PULLING ON THE CABLETHE PLATE MUST NOT BE REMOVED IntroductionNEVER USE THE COOKING HOB AS A WORK SURFACE Instructions for the installer 2. INSTALLATION OF THE APPLIANCE2.1 Levelling 2.2 Electrical connection2.3 Instruction for wall fixing only on some models Instructions for the installerFor operation on 380-415V3N∼ use an H05RR-F-type five-core cable 5 x 2.5 mm2Instructions for the user 3. DESCRIPTION OF CONTROLS3.1 Front control panel DESCRIPTION OF SYMBOLSFUNCTION SWITCH KNOB Instructions for the userCOOKING HOB CONTROL KNOB Standard heating Double heating3.2 Electronic Analogue Clock on some models only 3.2.1 Setting the timeInstructions for the user LIST OF FUNCTIONSInstructions for the user 3.2.2 Minute-minder3.2.3 Programming Instructions for the userCaution cooking times of more than 6 hours cannot be set Instructions for the user 3.2.4 DEMO Function4.1 Cooking zones 4. USE OF THE COOKING HOBInstructions for the user Instructions for the user 4.2 Cooking tipsMake sure that children never touch the cooking hob 5.1 Warnings and general advice 5. USE OF THE OVEN5.2 Oven Light 5.3 Storage compartmentAccessories on Request 6. AVAILABLE ACCESSORIESInstructions for the user 7. COOKING HINTS 7.1 Traditional cookingFUNCTION SWITCH THERMOSTAT SELECTOR SWITCH FROM 50 TO 250C Instructions for the user7.2 Hot-air cooking 7.3 Hot-air grillingFUNCTION SWITCH THERMOSTAT SELECTOR SWITCH FROM 50 TO 250C FUNCTION SWITCH THERMOSTAT SWITCH FROM 50 TO 250C7.4 Defrosting 7.5 Variable grill cookingFUNCTION SWITCH THERMOSTAT SWITCH IN POSITION FUNCTION SWITCH THERMOSTAT SWITCH IN MAX POSITION7.6 Spit cooking FUNCTION SWITCH THERMOSTAT SWITCH BETWEEN 50 - 250CTHERMOSTAT SWITCH BETWEEN 50 - 230C Instructions for the userTRADITIONAL COOKING GRILLING7.7 Recommended cooking table Instructions for the userHOT-AIR COOKING Instructions for the userFIRST COURSES MEAT8. CLEANING AND MAINTENANCE 8.1 Cleaning the glazed ceramic hob8.2 Cleaning stainless steel NEVER USE A STEAM JET TO CLEAN THE APPLIANCE8.3 Cleaning of the oven without self-cleaning panels 8.3.1 Self-cleaning liners8.3.2 Using the self-cleaning liners 8.3.3 Looking after the self-cleaning liners8.3.4 Assembling the self-cleaning liners 8.4 Door glassInstructions for the user 9. EXTRAORDINARY MAINTENANCE 9.1 Replacement of light bulbBefore any intervention, disconnect the power supply of the device Instructions for the user9.3 Oven door seal 9.2 Removing the doorInstructions for the user