Smeg ALFA135BE Levelling, Steam vent pipes, Safety thermostat, Instructions for the Installer

Instructions for the Installer

In case of connection to the electrical mains by means of socket and pin, the connection must be completed with a three-pin plug of suitable rating (25A), or, for operation at 380-415V2N∼or 380-415V3N∼, a five-pin plug (16A). The power supply plug and wall socket must be of the same type (in compliance with CEI standards). Check that the power supply line is properly earthed. The use of reductions, adapters or junctions is not recommended.

If a permanent connection to the elctrical mains is used, the appliance's power supply line must be fitted with an omnipolar breaking device with contact breaking gap of at least 3 mm, located in an easily accessible position close to the appliance itself.

WARNING: if the mains voltage drops below 190 VAC there might be an impairment of the oven's performance; this is not due to the appliance itself.

2.1.1 Safety thermostat

The oven is fitted with a safety device tripped in case of a serious malfunction. To reset the safety device, call the after-sales service.

The manufacturer declines all responsibility for injury or damage caused by failure to comply with the above regulations or deriving from tampering with even just one part of the appliance.

2.2Levelling

Level the oven by means of its four adjustable feet. To make the adjustment, undo the lock-nut and unscrew the foot. The adjuster screw travel is 10 mm.

2.3Steam vent pipes

Depending on the model, the back of

the oven is fitted with two pipes which vent the steam produced during cooking. These pipes must be left free of all obstructions. Take care not to crush them.

22