Instructions for the Installer
2. INSTALLING THE OVEN
The oven is designed for free-standing installation on a horizontal work- top. It must be far enough from the wall behind it to allow easy access to the terminal board for connection of the power supply lead. Installation must be carried out by a qualified engineer in compliance with the relevant EEC DIRECTIVES.
2.1Electrical connection
Check that the power supply voltage and size are as specified on the nameplate on the side of the oven. This nameplate must never be
removed.
The oven is fitted with a H07RN-F three-core cable for operation at 240-240V∼.
For operation at 380-415V2N∼or 380-415V3N∼, the power supply cable has to be replaced and the connection to the terminal board modified. The terminal board can be accessed by removing the panel on the back of the oven.
The power supply lead supplied is of H07RN-F type, gauge 3 x 4 mm2.
For operation at 380-415V2N∼or 380- 415V3N∼, the power supply cable has to be replaced with one of H07RN-F type. The gauge of the wires in the new cable must be at least 2.5-1.5 mm2 (4 x 2.5 mm2 - 5 x 1.5 mm2), bearing in mind that the earth wire (yellow-green) must be at least 20 mm longer at the end for connection to the oven.
21
