Smeg ALFA141VE, ALFA141XE manual Instructions for the installer, 2.2Levelling, Safety thermostat

Instructions for the installer

When linking up to mains by plug and socket, the connection must be completed with a three-core plug of adequate capacity (25A), or, for operation at 380-415V2N∼or 380-415V3N∼, a five-core plug (16A). The plug and wall-mounted socket must be of the same type (in accordance with CEI regulations). Make sure that the supply line is suitably earthed. Avoid use of adapters and shunts.

If the appliance is connected to the electrical mains supply in a permanent manner, install a multipolar cut-out device on the line, with contact opening distance equal to or greater than 3 mm located near the appliance and in an easily reachable position.

WARNING: if the phase voltage drops below 190 VAC, the performance of the oven may suffer, not due to the product itself.

The terminal marked with this symbol connects parts together that are normally at zero potential. Connect the appliances appropriately using this terminal in order to make sure that they are equipotential.

2.1.1 Safety thermostat

The oven is equipped with a safety device that takes action in case of serious malfunction. To re-arm the safety device you must contact the technical assistance service.

The manufacturer declines all responsibility for damage to persons or things caused by the non-observance of the above prescriptions or deriving from tampering with any part of the appliance.

2.2Levelling

Level the oven on the ground using the four adjustable feet. In order to adjust them, loosen the lock nut and unscrew the foot. The adjustment screws have a range of 10 mm.

25