BThe ventilation hose should not be connected to the chimney of a stove or a fireplace.
BDo not operate your product at the same time with heaters such as a coal or gas stove. Airflow may cause the chimney to flare up.
Connection to water drain (Products with a condenser);
In products equipped with condenser unit, water accumulated during the drying cycle accumulates in the water tank. You should drain accumulated water after each drying cycle.
You can directly drain accumulated water through the water drain hose supplied with the product instead of periodically draining the water collected in the water tank.
Connecting the water drain hose:
1.Pull the hose out by its end to remove it from the product. Do not use any tools to remove the hose. Attach the drain hose adaptor to the end of this hose.
2.Connect the special drain hose supplied with the product to the hose adaptor fitting.
3.Connect the other end of the drain hose directly to the wastewater drain or to the washbasin. The fitting must
always be secured in every type of connection. Your house may flood if the hose comes out of its housing during water discharge.
CWhen you direct the water drain to outside, “Water Tank” warning light will turn on at the end of each programme.
Important:
•The hose should be attached to a height of maximum 80 cm.
•Make sure that the hose is not pinched or bend.
•The end of the hose should not be bent, it should not be stepped on and it must not be folded between the drain and the product.
Connecting the water drain hose for models with the water tank at the bottom;
Connection pipe to water drain is at the bottom rear of your machine.
1.Remove the bracket and the rubber cap.
2.Attach the drain hose and replace the bracket to its position.
Important:
C There is no pump in the machine, so ensure that the hose is placed to allow a easy water flow.
C The end of the hose should never be higher than the level of the water outlet
6 - EN
