Changing the Nozzles

REPLACING THE BURNER SECTION NOZZLES

1Remove the grids and refractory plates inside the barbecue section.

2Undo the screws (for each burner) on the rear cross-member.

3Remove the burners from the barbecue section.

4Using a 7 mm socket wrench, undo the nozzles on the taps (replace the nozzles as specified in the table above).

5Adjust the primary air flows (see adjusting primary air flows section).

6Put the burners back into place correctly and tighten the fixing screws.

1	Remove the rear of the barbecue by undoing the
	supporting screws.
2	Using a 7 mm spanner, unscrew the nozzle (1).	1	2
3	Replace the nozzles as specified in the table	1	2
3	Replace the nozzles as specified in the table
	above. To make it easier to fit the nozzle, the nut
	(2) can be unscrewed.
4	Retighten the nut (2) with great care.
5	Fit the rear part back into place and screw on with
	the fixing screws.

1Remove the grid, the burner cap and the flame diffuser ring.

2Using a 7 mm socket wrench, unscrew the burner nozzle.

3Replace the nozzle as specified in the table above.

4Put the burner, the burner cap and the flame diffuser ring back into place correctly.

5Fit the rear part back into place and screw on with the fixing screws.