Smeg BQ6030 manual Adjusting the Burner Minimum Setting, Converting from LPG to Natural GAS

Instructions for the Installer

ADJUSTING THE BURNER MINIMUM SETTING

CONVERTING FROM LPG TO NATURAL GAS

Perform the operations described below on all the gas taps.

1Pull off the knob.

2Make sure that the by-pass inside is screwed fully down. Use a screwdriver inside or on the side of the rod (see right).

3Turn the bypass as stated in the BURNER

CHARACTERISTICS, NOZZLES AND GAS CONSUMPTION table (see page 10).

4When adjustments are complete, fit the knob, light the relative burner and turn it to the minimum setting . The flame should be even at the minimum setting.

5Check that the flame remains stable when the knob is turned quickly from the maximum to the minimum setting. The flame must not go out.

6If the minimum flame is not even, remove the knob and make small clockwise or anti-clockwise adjustments to the bypass then check stability again. Otherwise the minimum flame has been adjusted successfully.

CONVERTING FROM NATURAL GAS TO LPG.

Perform the operations described below on all the gas taps.

1Pull off the knob.

2Turn the by-pass inside, screwing it fully down. Use a screwdriver inside or on the side of the rod (see right).

3For the grill tap, after screwing the bypass fully down back it off by 1+1/4 turn.

14