Instructions for the User
Before starting the automatic cleaning cycle, make sure that the oven does not contain any foods or large spills from previous cooking operations inside.
A door interlock device means that the door cannot be opened during the procedure.
If the oven is installed underneath a hob, make sure that the burners or electric plates remain off during the automatic cleaning cycle.
12.7 Before starting the automatic cleaning cycle
Pyrolysis may be carried out at any time of the day or night (if you wish to benefit from the lower cost of electricity overnight).
•only the baking tray, the oven tray and the roof liner may be left inside the oven since they will withstand the high temperatures of the pyrolysis process; all the other accessories must be removed from inside the oven.
•remove the most obvious dirt (cleaning it by Pyrolysis would take too long);
•make sure that the oven door is firmly closed;
•when setting the cleaning cycle duration, refer to the chart below:
| LIGHT DIRT | MEDIUM DIRT | HEAVY DIRT |
CLEANING DURATION: | 90 MIN. | 105 MIN. | 120 MIN. |
|
|
|
|
During the first automatic cleaning cycle unpleasant smells may occur due to the normal evaporation of oily manufacturing substances. This is an absolutely normal phenomenon which disappears after the first cleaning cycle.
During the automatic cleaning cycle the fans make more noise because they are running at higher speed. This is an absolutely normal function, intended to provide more effective heat dispersal. At the end of the pyrolysis process the fans continue to run automatically for long enough to prevent overheating of the sides of the cabinet and the front of the oven.
12.8 Setting the automatic cleaning cycle
Turn the function selector knob to the 
symbol to start the pyrolysis cycle. The orange thermostat light comes on, followed a few minutes later by the red “door interlock” light to indicate that the appliance's door has been locked because of the high temperature inside the oven. As soon as the function selector
knob is turned to 
, the display shows 
to indicate that the pyrolysis cycle will start immediately and will last an hour and a half. The duration of the pyrolysis cycle can be increased up to a maximum of 3 hours. To do this, after the pyrolysis cycle starts press the 
key followed within a few seconds by the value modification keys 
or 
. A few seconds after the last key is pressed, the display will show the letter P followed by the pyrolysis duration just set, and the letter A will stop flashing. After starting the pyrolysis procedure, and modifying its duration as just described if required, the cleaning cycle end time can also be programmed.
Press button 
. The letter A will flash on the display, which will also show the sum of the current time plus the duration of the pyrolysis cycle (e.g.: Current time: 12.10 - Programmed duration: 2.00 - Figure shown: 14.10). At this point, the value modification keys 
or 
can be used to set the cleaning cycle end time. A few seconds after the last key is pressed, the display will show the current time and the orange light will go out; it will come back on at the preset time.
Warning: do not leave anything in the oven during the pyrolysis cycle. Keep children at a safe distance and take care, especially if the cycle is set to start with a delay.
Use of the hob is not permitted during the pyrolysis cycle.
59
