User instructions
END PROGRAM
When the program finishes, a buzzer sounds briefly and all the PROGRAM PHASES lights
(7)flash.
Press any of the SELECTION PROGRAMS buttons (2), stops the light flashins, and the dishwasher is now ready to perform a new cycle; opening and shutting the door or switching the appliance off and on has the same effect.
INTERRUPTION OF A PROGRAM
In order to interrupt a running program it is necessary:
•press one of the SELECTION PROGRAMS buttons (2), the light of the current phase will go out;
•keep the button pressed until the PROGRAM PHASES lights (7) come on (confirmation buzzer);
•start the program (see “START PROGRAM”).
TO CHANGE A PROGRAM
To change the running program it is necessary:
•to interrupt the running program (see “INTERRUPTION OF A PROGRAM”);
•select the new program;
•start the new program (see “START PROGRAM”).
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see
“INTERRUPTION OF A PROGRAM”).
Now press buttons P1+P2 simultaneously and the first three programs lights will come on.
In case that the door is opened during the operation, to the next door closing it is going to be necessary to start the program as shown in paragraph “START PROGRAM”. The program will resume from the point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will start about 30 seconds later.
39
