Changing the light bulb...
1.Reach behind the control console to find bulb
2.Remove bulb.
3.Replace with a
Adjusting the refrigerator shelves...
To remove the shelf:
1. First, remove food from shelf.
2. Slide shelf straight out to stop.
GUIDE STOP.
3. Lift front, slide shelf the rest of the way out. SHELFSTOP
To replace the shelf:
1.Fit back of shelf on top of guides with wire stops on the bottom of guides.
2.Lift front, slide shelf in until it clears guide stops.
Removing crisper and crisper cover...
To remove the crisper:
l Slide crisper straight out.
To remove the cover:
1.Lift back, then slide to the rear until the front can be lifted.
2.Lift cover up and out.
To replace the cover:
1.Slide the front cover tabs into the back of the front supports on the refrigerator walls.
GUIDE
LIFT THE FRONT, THEN THE BACK.
OUT.
2. Lower back into place.
Ice cube trays... | h | iI1i |
For best results when freezing ice cubes, place
ice cube trays
If cubes are not used, they may shrink. The longer cubes are stored, the smaller they get.
? | EE’:?both | ends. |
2. | Slightly | twist. |
Sounds you may hear...
Your new refrigerator may make sounds that your old one didn’t Because the sounds are new to you, you might be concerned about them. Don’t be. Most of the new sounds are normal. Hard surfaces like the floor, walls and cabinets can make the sounds seem louder.
The following chart describes the kinds of sounds that might be new to you, and what may be making them.
l
l
Possible | Sounds: | Probable | Causes: |
|
|
|
| ||
Wafer | Sounds: | When | the | refrigerator | stops running, | you may hear | gurgling | in the | |
|
| tubing for a few minutes after it stops. |
|
|
| ||||
Running | Sounds: | Your | refrigerator | has | a | compressor | and motor. | ||
|
| It will run longer than older designs. It may even seem to run most | |||||||
|
| of the | time. |
|
|
|
|
|
|
6
