Install properly... | Remove sales labels... |
|
|
| |||||
| Remove the Consumer Buy Guide label, tape | ||||||||
| and | any | inside |
| labels | before | using the | re- | |
| frigerator. To remove any remaining glue: |
| |||||||
| 1. Rub briskly with thumb to make a ball then | ||||||||
| remove. |
|
|
|
|
|
|
| |
| OR |
|
|
|
|
|
|
|
|
| 2. Soak | area | with | liquid hand | dishwashing |
| |||
| detergent before removing glue as described | ||||||||
| in | step | 1. |
|
|
|
|
|
|
| DO | NOT USE rubbing | alcohol | or | flammable | or | |||
| toxic solvents, such as acetone, gasoline, car- | ||||||||
| bon | tetrachloride, |
| etc. | These | can | damage | the | |
| material. |
|
|
|
|
|
|
| |
| NOTE: DO NOT REMOVE ANY PERMANENT IN- | ||||||||
| STRUCTIONS LABELS INSIDE YOUR REFRIGER- | ||||||||
| ATOR. |
|
|
|
|
|
|
| |
| Do not remove the Tech sheet fastened under | ||||||||
| the refrigerator | at | the front. |
|
|
| |||
1.Allow 3 inches (7.5 cm) between overhead cab- inets and the refrigerator top.
2.Allow at least an inch (2.5 cm] between the re- frigerator condenser on the back and the wall
3.Allow li2 inch (1.25 cm) on each side of the re- frigerator for ease of installation.
4.If the refrigerator is to be against c wall, you might want to leave extra space on the hinge side so the door can be opened wider.
Clean it...
Clean your refrigerator before plugging it in or using it. See cleaning instructions on page 7.
Plug it in...
Level refrigerator-freezer. ..
LEVE
LEG
RAISELOWER
1.Keep the 4 bolts that held refrigerator in ship- ping crate. They are the levelling legs.
2.Screw these bolts all the way into bolts holes at the bottom corners of refrigerator.
3.Adjust each leg until the refrigerator won’t rock. Slide refrigerator into place.
4.Adjust front legs to level the refrigerator.
5.Check with level.
4
REFRIGERATOR |
|
|
| ||||
GROUNDING | PLUG |
| |||||
POWER CORD |
| ||||||
|
|
|
|
| |||
RECOMMENDED | GROUNDING | METHOD |
| ||||
A 115 Volt, 60 Hz., AC only | 15 or 20 | ampere tused | |||||
and | properly | grounded | electrical | supply | is | ||
required. | It is recommended |
| that a separate | cir- | |||
cuit | serving | only | this appliance | be | provided. |
| |
Do not use an extension cord. Use a recepta- cle which cannot be turned off with a switch or pull chain. See Individual electrical requirements and grounding instruction sheet in your literature package
l Move Run Switch to RUN.
NOTE: The refrigerator motor will not operate until the Run Switch is on RUN.
