How to install Water Line (Dispenser Models Only)
3. Remove any substances in the filter. |
1.The water pressure should be 2.0~12.5kgf/cm2 or more to run the automatic icemaker.
Checkup your tap water pressure ; if a cup of 180cc is full within 10 seconds, the pressure is OK.
2.When installing the water tubes, ensure they are not close to any hot surfaces.
3. The water filter only filters water ; it does not eliminate any bacteria or microbes.
4.If the water pressure is not so high to run the icemaker, call the local plumber to get an additional water pressure pump.
5.The filter life depends on the amount of use. We recommend you replace the filter at least once every 6months.
When attaching the filter, place it for easy access (removing & replacing)
6.After installation of refrigerator and water line system, select [WATER] on your control panel and press it for 2~3 minutes to supply water into the water tank and dispense water.
7.Use sealing tape to every connection of pipes/tubes to ensure there is no water leak.
8.The water tube should be connected to the cold water line.
WATER SUPPLY KIT
Check the parts below for installing water supply. Some other necessary parts are available at your
local service agents.
Connector(3012020700) (3014454520)
(3011202000) (7112401211)
(3019974100) (A:3019503200 B:3019503300)
1) Open the main tap water valve and check if water comes out of |
the Water Tube. |
2) Check if the Water Valve is open in case water does not come out. |
3) Leave the valve open until clean water is coming out. |
Initial water may contain some substances out of filter (manufacturing process).
4. Attach the Filter Box | |
1) | Screw and fasten the filter holder to the left/right side of the back |
| of refrigerator. |
| In case the holder is not fastened well, remove the back paper |
| of the tape on the filter holder and attach it." |
2) | Insert the filter box into the holder. |
5. Connect the Water Tube to the refrigerator. | |
1) Remove the rear cover at the bottom back of the refrigerator. | |
2) | Insert the fastening ring into the Water tube. |
| (Be careful to follow the direction of the nut.) |
Water
Water Tube
Installation Procedure (Dispenser Models Only)
1. Join Connector to the tap water line
<Figure A> | <Figure B> |
3) Insert the Water Tube into the top of the Water Valve, turn the nut |
clockwise to fasten it. (The Water valve is to the right of the motors.) |
4) Check for any bent tubes or water leaks; if so, |
procedure. |
5) Replace the rear cover. (The Water Tube should be placed |
between the groove of the refrigerator back and motor cover.) |
Set the tube upright as the figure shows.
Tube
Nut
Water Valve
Place the rubber washer inside the tap connector and screw onto the water tap.
6.Fasten the Water Tube.
1)Fasten the Water Tube with the [Fastener A] .
2)Check if the tube is bent or sqeezed. If so, set it right to
prevent any water leak. | Fastener A |
Water Tube
2. Get ready to install the Water Filter
1) Measure an approximate distance between the filter and the Water Tube and cut the tube off filter vertically.
2) Connect the tubes to the filter as the figure shows.
Leave a sufficient distance when cutting the tubes.
7.After installation of Water Supply System
1)Plug in the refrigerator, press the [WATER] button on the control panel for 2~3 minutes to remove any air (bubble) in the pipes and drain out the initial water.
2)Check for the water leaks again through the water supply system (tubes, connectors and pipes) Rearrange the tubes again and do not move the refrigerator.
Connector Tap
Water Tube
20 | 21 |