Replacing Freezer Door 
Insert the water tube into the hole of the | Insert the bottom hole of freezer door | Let the top of door close to the |
1bottom hinge pin first (Dispenser | 2straight to the bottom hinge pin. | 3 cabinet and insert the top hinge pin |
Models Only). Insert the bottom of |
| to the top hole of freezer door. |
freezer door into the bottom hinge pin. |
| ( Insert the back of hinge to the |
|
| groove of protrusion first, then front |
| @ | to the top hole of door.) |
|
| |
|
| ! |
| ! |
|
Turn the hinge fastener tightly to the |
|
| Insert the water tube far into the | ||
4 end. |
| 5 coupling. | |||
Connect harness wirings and screw |
|
| (Dispenser Models Only) | ||
ground wire. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Replacing Refrigerator Door 
Refrigerator Leveling & Door Adjustment ( If needed. )
Refrigerator must be level in order to maintain optimal performance and desirable front appearance. (If the floor beneath the refrigerator is uneven, freezer and refrigerator doors look unbalanced.)
In case freezer door is lower than refrigerator door...
Insert a screw driver (flat tip) into a groove of the left wheel (bottom of freezer) and turn it clockwise until the door is balanced. (clockwise to raise freezer door ; counterclockwise to lower)
In case refrigerator door is lower than freezer door...
Insert a screw driver (flat tip) into a groove of the right wheel
(bottom of refrigerator) and turn it clockwise until the door is balanced. (clockwise to raise refrigerator door ; counterclockwise to lower)
1Insert the bottom hole of refrigerator door straight to the bottom hinge pin
2Let the top of door close to the cabinet and insert the top hinge pin to the top hole of freezer door.
( Insert the back of hinge to the groove of protrusion first, then front to the top hole of door.)
@
!
3Turn the hinge fastener tightly to the end.
Connect harness wirings and screw ground wire.
Click and screw the top hinge cover.
! 
Front Cover
After installation and/or door leveling, fasten front cover with screws. (Remove the screws on the front bottom panel first. Click and screw the cover)
Caution ● The front of refrigerator needs to be higher just a little than the back for easy door closing, but if the wheel is raised too much for door balance, i.e. front of
refrigerator is higher than the back, it can be difficult to open the door.
18 | 19 |
