Instructions for the installer
2 POSITIONING OF THE HOB
The following operation requires building and/or carpentry work so must be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as they are heat resistant (T 90°C).
Never use silicone or other insulating products when installing the appliance; use only the rubber gasket provided.
2.1Attachment to support structure
Create an opening with the dimensions shown in the figure in the top surface
of the counter, keeping a minimum distance of 50 mm from the rear
border. This device is classified "type Y" as
regards risks against fire and it can be set adjacent to walls that are higher
than the work surface, provided that a distance of 145 mm. is respected (as shown in the figure) to prevent damage due to overheating..
Make sure there is a minimum of 750 mm between the hot plate flames and any shelf that may be installed directly above them. Accurately position the gasket provided all around the outer edge of the hole in the top surface as shown in the figures below, pressing it down so as to make it adhere properly. Refer to the dimensions shown in the diagram, bearing in mind that the sides A must be flush with the hole. Fix the hob to the unit using the brackets B provided.
Carefully trim any excess from border C of the gasket. The distances in the following drawing refer to the hole on the inner side of the gasket.
24
