Manuals / Smeg / Kitchen Appliance / Dishwasher

Smeg IG40521W2, IG40521B2, IG40521X2 End Of Cycle, Removing The Dishes, User instructions

Models: IG40521X2 IG40521B2 IG40521W2

1 27

Download 27 pages 12.93 Kb

Page 12

END OF CYCLE

User instructions

If it is necessary to open dishwasher door during the washing cycle, there will be a 1-minute delay before the program can be resumed. After correctly closing the door, the washing program will start again from where it was interrupted. This operation may negatively affective the progress of the washing cycle.

END OF CYCLE

At the end of the washing program the selector will be on one of the STOP markers, depending on the program carried out. Switch off the dishwasher by pressing the ON/OFF key (2).

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.

39

Image 12

Smeg IG40521W2, IG40521B2, IG40521X2 instruction manual End Of Cycle, Removing The Dishes, User instructions

Contents

DISHWASHER Contents Safety instructions 1. Safety and operating instructionsUSES OTHER THAN THOSE DESCRIBED ABOVE NEVER BE REMOVEDSafety instructions Safety instructions AQUASTOP MODELSAPPLIANCE Installation instructions 2. Installation and hook-up2.1 Water supply connection CONNECTING TO THE WATER SUPPLY 2.2 Electrical connectionDRAIN CONNECTION Installation instructionsUser instructions 3. Description of the controls3.1 Front panel 1WASHING PROGRAM SELECTOR 2ON/OFF KEYSETTING THE WASHING PROGRAM TABLE OF PROGRAMSUser instructions 3.2 Washing programs TABLE FOR CERTIFICATION BODIESReference standard Before starting a washing program make sure thatCANCELLING THE CURRENT PROGRAM CHANGING THE PROGRAMTO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT User instructionsEND OF CYCLE REMOVING THE DISHESUser instructions 4.1Using the water softening system 4. Operating instructionsUser instructions ADJUSTING THE WATER SOFTENING SYSTEM User instructions4.2 Using the rinse aid and detergent dispensers WATER HARDNESS TABLEUser instructions ADJUSTING THE RINSE AID DISPENSER SETTING ADDING THE RINSE AIDUser instructions ADDING THE DETERGENT User instructionsAlso available are tablet detergents which state that that no salt or rinse aid is required. In some cases, these detergents might not give good results, especially with short and/or low-temperaturewashing cycles User instructions4.3 General warnings and recommendations User instructionsItems which are not dishwasher-safe User instructions4.4 Using the baskets LOWER BASKETLOADING THE LOWER BASKET User instructionsCUTLERY BASKET UPPER BASKETUser instructions ADJUSTING THE UPPER BASKET LOADING THE UPPER BASKETUser instructions 5. Cleaning and maintenance CLEANING THE WATER INTAKE FILTERCLEANING THE SPRAY ARMS 5.1 General warnings and recommendationsCLEANING THE FILTER UNIT PROLONGED DISUSEFill the rinse aid dispenser Shut off the water supply tapTROUBLESHOOTING MINOR PROBLEMS If the program fails to start, check thatUser instructions User instructions there is rinse aid inside the special container