Smeg KLVS50EB, KLVS52X Cancelling The Current Program, Changing The Program, User instructions

Models: KLVS51NE KLVS50EB KLVS52X

1 37
Download 37 pages 11.76 Kb
Page 7
Image 7
CANCELLING THE CURRENT PROGRAM

User instructions

CANCELLING THE CURRENT PROGRAM

To annul the current program, press the START/PAUSE button (2) for a few seconds, until the PROGRAM STARTED light (5) stops flashing. Now press the START/PAUSE button (2) again until "P0" appears on the display (about 10 seconds).

CHANGING THE PROGRAM

To modify the program keep the START/PAUSE button (2) pressed for a few seconds, until the PROGRAM STARTED indicator light (5) stops flashing, then select the new program following the instructions provided above; press the START/PAUSE button (2) again and keep it pressed for a few seconds, until the indicator light (5) starts to flash again.

DELAYING THE PROGRAM (available in all programs except the soak program)

The PROGRAM DELAY button (3) can be pressed to delay the start of the washing program by up to 12 hours. This means that the dishwasher can be operated at the time of day of your choice.

Press the PROGRAM DELAY button (3) again; the 3-FIGURE DISPLAY (6) will show the number of hours of delay with which the appliance will start.

The 3-FIGURE DISPLAY (6) shows the set washing program duration in hours and minutes.

After setting the delay, start the program: press the START/PAUSE button (2) for a few seconds, until the PROGRAM STARTED light (5) starts flashing.

The appliance will prewash the dishes, after which the "program delay" set previously will come into effect.

To cancel the program delay once the wash has started, proceed as follows:

press the START/PAUSE button (2) for a few seconds, until the PROGRAM STARTED light

(5) stops flashing;

press the PROGRAM DELAY button (3) several times until the program delay returns to zero;

press the START/PAUSE button (2) to start the program.

N.B.: It is not possible to select the “delay program” when the program have already began.

TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT

Always try to run the dishwasher fully loaded.

Do not wash the dishes in running water.

Use the washing program that is most appropriate for each type of load.

Do not carry out any preliminary rinsing.

If available, connect the dishwasher to a hot water supply up to 60°C.

When possible, disable the drying cycle and leave the door open at the end of the washing cycle: the residual air and heat will dry the dishes perfectly.

TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT

The phosphates contained in dishwasher detergents are harmful to the environment. To avoid using excessive amounts of detergent and to save on electricity, observe the following:

separate the more delicate items from dishes that are more resistant to aggressive detergents and high temperatures;

do not pour the detergent directly on the dishes.



Page 7
Image 7
Smeg KLVS50EB Cancelling The Current Program, Changing The Program, To Save On Energy! … And Protect The Environment