Smeg KLVS52X, KLVS50EB, KLVS51NE instruction manual Starting the Dishwasher

User instructions

STARTING THE DISHWASHER

After carrying out all the operations described above correctly, to start the dishwasher simply press the press the START/PAUSE button (2) for a few seconds until a beep sounds (the PROGRAM STARTED (5) light starts to flash). The 3-FIGURE DISPLAY (6) will show the duration of the program in minutes. The duration time is only approximate, because it depends on the washing conditions (quantity of dishes, water temperature, etc.), and is also continually updated as the washing program progresses.

The 3-FIGURE DISPLAY (6) shows the estimated duration of the washing program.

If it is necessary to open dishwasher door during the washing cycle, there will be a 1-minute delay before the program can be resumed. After correctly closing the door, press the START/PAUSE (2) button again. This operation may negatively affective the progress of the washing cycle.

END OF CYCLE

At the end of the program the PROGRAM STARTED (5) light stops flashing and "End" appears on the 3-FIGURE DISPLAY (6).

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.