
INSTALLATION
Drilling the Support surface and Fitting the Hood
SCREW FITTING
•The hood support surface must be 220 mm above the bottom surface of the wall units.
•Drill the support with a ø 4,5 mm drill bit, using the drilling template provided.
•Cut a hole ø 150 mm in size on the support surface, using the drilling template provided.
•Fix using the 4 screws 12a (4,2 x 44,4) provided.
SNAP-ON FITTING
•The hood can be installed either directly on the bottom surface of the wall units (min. 650 mm above the hob) using
•Cut a fitted opening in the bottom surface of the wall unit, as shown.
•Insert the hood until the side supports snap into place.
•Lock in position by tightening the screws Vf from underneath the hood.
Hood Type | 60 | 90 |
L | 598 | 898 |
220
264
15
L1
Vf
GB |
| 12 |