GB
b.Drill a hole on the back and in the top of the cabinet for the ventilation duct (a good rule of thumb is to make the diameter of the hole 15 mm larger than that of the duct used).
c.Insert the Cscrews supplied with the hood into the F holes and tighten the hood to the cabinet (Fig. 7).
Assembly using side bracket (if supplied)
The hood can also be mounted by means of two brackets supplied with the hood. To fix the hood in this way (Fig.
a.Drill two holes Ø 2 mm on the two sides of the cupboard from the inside using the template Q supplied.
b.Fix the two brackets T to the upper side of the hood using screws V 4,2 x 35 (the position of the brackets can be adjusted in width according to the thickness of the cupboard panels).
c.Fix the hood, through the brackets already mounted, on the inside of the cupboard using screws Z3,5 x 13 (two each side).
Adjusting the
The hood can be installed beneath cabinets with varying depths. Adjustments for opening and closing the drawer can be made based on your specific needs.
To adjust the drawer, remove the ventilation grates by loosening the M screws and adjusting the P brackets. Then retighten the M screws (Fig. 10).
Using the hood
Thehoodisprovidedwithseveralspeeds.Forthebestperformance, we recommend using the low speeds in normal conditions and the high speeds when strong odour and vapour concentrations are present.
We recommend starting the hood a few minutes before cooking and keeping it running for at least 15 minutes until all the odours have been eliminated.
Maintenance
Caution! Before performing any maintenance, disconnect the hood from the electrical supply.
Grease Filter
The grease filter serves to trap grease particles by suspending them.
1.Synthetic Filter (thickness:
2.Thin Synthetic Filter (approximately 1 mm thick): replace when the coloring from the top is visible on the bottom part.
3.Thin Synthetic Filter (approximately 1 mm thick - without saturation indicator) replace every two months.
4.Metal Filter: unlimited life; wash every month in warm soapy water, or, if possible, in the dishwasher (60°C). Let dry before
reinstalling it.
Removing the Grease Filters (for models wtih grease filter support grates)
To remove the dirty grease filter, proceed as follows:
a)
b)Remove the Lfasteners for the grease filter and remove it (Fig. 11). If special metal filters have been installed, press on the plastic springs (S) to unhook them (Fig. 4).
c)When washing or replacing the grease filter, wash the grate as
well with warm soapy water.
d)Remount the new filter or the old one after it has dried thoroughly.
Charcoal Filter
The charcoal filter serves to eliminate odours that form during the cooking process. Under normal use conditions, the filter should be replaced every 4 months. It can be ordered from the retailer. The charcoal filter must never be washed.
To remove the charcoal filter, proceed as follows:
a.Remove the
b.Remove the grease filters and open the light cover support (or the greas filter support grate).
c.Turn the center knob on the charcoal filter in the counterclockwise direction and remove the filter from its seat (Fig. 6, in reverse).
Replacing the Lamp
a.Remove the
b.Open the light cover support or the back grease filter support grate.
c.Replace the burned out lamp, using only 40W (max) olive- shaped bulbs (E14).
d.Before calling for customer service because the lighting system does not work, make sure that the lamps are screwed in tightly.
Cleaning
The cooker hood should be cleaned regularly internally and externally.
For cleaning use a cloth moistened with denatured alcohol or neutral liquid detergents. Avoid abrasive detergents.
Warning:
Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks. Therefore we recommend observing these instructions.
