“Cottons 40” program instead of “Cottons 60” program. Select the “Cottons 40” program. Start the program.

Switching the machine to standby mode

Press “Start/Pause/Cancel” button momentarily to switch your machine to the standby mode. Auxiliary functions can be cancelled or selected in accordance with the step the program is at. The door can be opened if the water level is suitable. Laundry may be added / taken out by opening the door.

Child-proof lock

You can protect the appliance from being tampered by children by means of the child- proof lock. In this case, no change can be made in the running program.

The machine is switched to child-lock by pressing the 1st and 2nd auxiliary functions from the left for 3 sec. Child-proof lock lamp on the program follow-up indicator will light up when the child-proof lock is activated. To deactivate the child-proof lock, press the same buttons for 3 sec.

Ending the program through canceling

In order to cancel the selected program, press the “Start/Pause/Cancel” button for

3 seconds. You can select and start a new program when the “Ready” light is lit.

The “Spin” light illuminates if the cancellation process is activated in the middle of the program and the machine can either drain all the water or can take in water 3 times at most to cool down the clothes and perform the draining process.

The program which is selected first will keep on going even if the position of the program selection button is changed. A new program can be selected or started after “Program is cancelled” in order to change the washing program.

End of program

The “Ready” lamp on the program follow-up indicator will light up when the program comes to an end. The door can be opened and the machine is ready for a second cycle now. Press the “On/Off” button to shut down the machine.

5 Maintenance and cleaning

Detergent Drawer

Remove any powder residue buildup in the drawer. To do this;

1.Press the dotted point on the siphon in the softener compartment and pull towards you until the compartment is removed from the machine.

CIf more than a normal amount of water and softener mixture starts to gather in the softener compartment, the siphon must be cleaned.

2.Wash the dispenser drawer and the siphon with plenty of lukewarm water in a washbasin.

3.Replace the drawer into its housing after cleaning. Check if the siphon is in its original location.

Inlet water filters

There is a filter at the end of each water intake valve at the back side of the machine and also at the end of each water intake hose where they are connected to the tap. These filters prevent the foreign substances and dirt in the water to enter into the machine. Filters should be cleaned as they get dirty.

• Close the taps.

Remove the nuts of the water intake hoses to clean the surfaces of the filters on the water intake valves with an appropriate brush.

If the filters are very dirty, you can pull them out by means of pliers and clean them.

Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean thoroughly under streaming water.

Replace the gaskets and filters carefully to their places and tighten the hose nuts by hand.

9- EN

Page 9
Image 9
Smeg LBS105 manual Maintenance and cleaning, Child-proof lock, Ending the program through canceling, Detergent Drawer