GB
3. INSTALLATION INSTRUCTIONS
Important !
The appliance must be installed by a specialised technician according to current regulations. This washer dryer is very heavy. Take care when lifting it.
3.1 UNPACKING
The inside of the machine comprises a moving assembly which is blocked for transport purposes by the screws (A) located at the rear of the washer dryer.
1.Release the assembly by removing these screws with a 13 mm wrench.
2.Remove the screws (A) and relative spacers (B) from the back of the washer dryer.
3.To prevent water from entering the machine or people from touching live components with their fingers, close the four holes left open by the screws with the supplied plastic plugs (C).
Attention!
•Do not turn the machine upside down and do not place it on its side.
•Keep all the components used to block the drum assembly as they will be needed if you decide to move the appliance in future.
3.2 POSITIONING AND LEVELLING
1.Place the appliance in the chosen position.
2.Carefully level the machine in all directions using a spirit level and adjusting the height of the feet if necessary. After adjusting the machine, lock the feet with the relative lock nuts.
The water inlet and drain hoses can be turned to the right or left depending on installation requirements.
Attention!
•Carry out this operation carefully to prevent the washing machine from vibrating, generating noise or moving during operation.
•If the appliance is installed on a carpeted floor, ensure that the openings on its underside are not obstructed.
•Make sure the washing machine does not touch walls, furniture, etc., while it is working.
•The appliance must not be installed behind a lockable door, or sliding door, or a door with hinge on the opposite side to the tumble dryer.
7
