Smeg LBS1600X manual Error Signals

GB

11The machine does not spin The unbalanced load sensor has triggered because the washing is not uniformly distributed inside the drum. If the washing is wet at the end of the cycle, distribute it well inside the basket and repeat just the spin cycle.

12 Draining water from the	In the event of a power failure or a fault in the appliance, the water inside
drum	the drum can be drained as described in paragraph 6.3

13The washing has not been correctly spun

14Residues of detergent on the washing

15The washing does not dry

Large items have rolled up and are not uniformly distributed inside the drum. Always wash large items together with small ones.

Many phosphate-free detergents contain substances that are difficult to dissolve in water.

Select the Rinse programme or brush the washing.

Check that:

-the water tap is open

			- the washing does not weight too much
			- the drying time is suitable.
			- sufficient drying time has been selected
			If the machine does not dry all the same, call the Service Centre to
			remove fabric frays from the fan and drying ducts.
16 Washing	results	are	- Too little detergent or an unsuitable detergent may have been
unsatisfactory			used.

- Stubborn stains were not pre-treated - The wrong temperature was selected - The drum was overloaded

ERROR SIGNALS

In the event of faults, the machine will display an error code.

Error code Problem

Door not closed properly. Close it.

Aquastop. Contact the nearest Service Centre after disconnecting the machine from the electrical power supply and closing the water tap.

No water for washing. See point 2 on the troubleshooting table.

The water does not drain. See point 4 on the troubleshooting table.

For all other error codes, contact the nearest Assistance Centre after disconnecting the power supply and closing the water tap.

25