2 Installation
Removing packaging reinforcement
Tilt the machine to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon.
Opening the transportation locks
ATransportation safety bolts must be removed before operating the washing machine! Otherwise, the machine will be damaged!
1.Loosen all the bolts with a spanner until they rotate freely (“C”)
2.Remove transportation safety bolts by turning them gently.
3.Fit the covers (supplied in the bag with the Operation Manual) into the holes on the rear panel. (“P”)
C Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future.
C Never move the appliance without the transportation safety bolts properly fixed in place!
Adjusting the feet
ADo not use any tools to loosen the lock nuts. Otherwise, they can be damaged.
1.Manually (by hand) loosen the lock nuts on the feet.
2.Adjust them until the machine stands level and firmly.
3.Important: Tighten all lock nuts up again.
Connecting to the water supply.
Important:
•The water supply pressure required to run the machine must be
•Connect the special hoses supplied with the machine to the water intake valves on
the machine.
•If you are going to use your double water- inlet machine as a single (cold)
•If you want to use both water inlets of the product, you can connect the hot water hose after removing the stopper and gasket group from the hot water valve.
*Applies for the products supplied with a blind stopper group.
• Models with a single water inlet should not be connected to the hot water tap.
When returning the appliance to its place after maintenance or cleaning, care should be taken not to fold, squeeze or block the hoses.
Connecting to the drain
The water discharge hose can be attached to the edge of a washbasin or bathtub. The drain hose should be firmly fitted into the drain as to not get out of its housing.
Important:
•The end of the drain hose must be directly connected to the wastewater drain or to the washbasin.
•The hose should be attached to a height of at least 40 cm, and 100 cm at most.
•In case the hose is elevated after laying it on the floor level or close to the ground (less than 40 cm above the ground), water discharge becomes more difficult and the laundry may come out wet.
•The hose should be pushed into the drainage for more than 15 cm. If it is too
long you may have it shortened.
•The maximum length of the combined hoses must not be longer than 3.2 m.
3- EN
