CHAPTER 3: INSTALLATION
13
3. Installation3.1 Getting Started
Before installing your ServSelect III switch, refer to the following list to ensure you have
all items that shipped with the appliance as well as other items necessary for proper
installation.
Supplied with the ServSelect III switch
• Power cord
• One null modem serial cable
• Rackmounting kit
• ServSelect III Installer/User Guide
• ServSelect III Quick Installation Guide
• ServSelect III Cable Quick Installation Guide
Additional items needed
One ServSelect III cable or SAM and UTP cabling per attached server or switch
3.2 Rack Mounting Your ServSelect III Switch
Your ServSelect III switch may be rackmounted using the brackets supplied in your
rackmounting kit. Before installing the switch and other components in the rack cabine t (if
not already installed), stabilize the rack in a permanent location. Install your equipment
starting at the bottom of the rack cabinet, then work to the top.
Figure 3-1. ServSelect III Switch Horizontal Installation
CAUTION:
Rack Loading - Overloading or uneven loading of racks may result in shelf or rack failure, causing
damage to equipment and possible personal injury. Do not exceed your rack loa d rating.
To install the 1U switch mounting bracket:
1. Remove the first two screws on each side of the switch.
2. Line up the holes in the “long side” of the kit’s side brackets with the screw ho les in
the switch.
3. With a Phillips screwdriver, fasten the mounting brackets to the switch using two
screws on each side.