CHAPTER 4: BASIC OPERATIONS
27
To assign names to servers:
1. In the Names dialog box, select a server name or port number and click Modify. The
Name Modify dialog box displays.
Figure 4-4. Name Modify Dialog Box
2. Type a name in the New Name box. Names of servers may be up to 15 char acter s long.
Supported characters include: A to Z, a to z, 0 to 9, space a nd hyphen.
3. Click OK to transfer the new name to the Names dialog box. Your selection is not
saved until you click OK in the Names dialog box.
4. Repeat steps 1 to 3 for each server in the system.
5. Click OK in the Names dialog box to save your changes.
-or-
Click X or press Escape to exit the dialog box without saving changes.
NOTE:
If a SAM has not been assigned a name, the EID is used as the default name.
Assigning device types
The ServSelect III switch automatically discovers cascaded KVM switches, but you will
need to specify the number of ports on the cascaded switch through the Devices dialog box.
You will see an Sw-8 or Sw-24 display in the Type category for the cascaded switch. Select
the switch from the list and the Modify button displays, allowing you to assign it the
appropriate number of ports.
NOTE:
The Modify
button will only be available if a configurable switch is selected.
To access the Devices dialog box:1. Press Print Screen to launch the OSD interface. The Main dialog box will appear.2. Click Setup - Devices. The Devices dialog box displays.