Instructions for the installer
5.2Regulation for LPG
Loosen screw C and push air regulator D to the bottom.
With a 7 mm wrench, remove nozzle E and replace it with the proper one (follow the instructions on the reference tables for the type of gas to be used). The torque wrench setting of the nozzle must not exceed 3 Nm.
Regulate the air by sliding regulator D until reaching distance “X” shown in the table in paragraph “5.4 Regulation of primary air ”.
Lock regulator D by tightening screw C.
Rated
BurnerheatingLPG – G30/G31 28/37 mbar capacity
(kW)
Nozzle |
|
| Reduced |
| Flowrate |
| Flowrate | |
diameter |
| mm |
| flowrate |
| g/h G30 |
| g/h G31 |
1/100 mm |
| 1/100 |
| (W) |
|
|
|
|
Auxiliary |
| |
Semi rapid |
| |
Medium rapid |
| |
Large rapid |
| |
UR | A | |
B | ||
|
1.0
1.6
2.3 |
3.0 |
3.6
48 |
62 |
75 |
82 |
76 |
48 |
30(**) | 33 (*) |
30(**) | 35 (*) |
40(**) | 43 (*) |
40(**) | 45 (*) |
48 (**) | 52 (*) |
450 73 72
500 116 114
700 | 167 | 164 |
800 | 218 | 215 |
1000 261 257
*/**: diameters marked * and ** must be fitted respectively on valves marked * and **shown inpoint “5.6 Regulation of minimum for natural gas”.
CAUTION: for references A and B on the lh UR and rh UR burners, see drawings at side.
5.3Regulation for natural gas
The hob has been inspected for G20 (2H) natural gas at a pressure of 20 mbar. To allow the unit to work with this type of gas, perform the same operations described in paragraph “5.2 Regulation for LPG ”, but choose the nozzles and regulate the primary air for natural gas, as shown in the following table and in paragraph “5.4 Regulation of primary air ”.
Burner
Auxiliary
Semi rapid
Medium rapid
Large rapid
Rated
heatingNatural gas – G20 20 mbar capacity
(kW)
Nozzle diameter | Reduced flowrate |
1/100 mm | (W) |
1.0 | 73 | 400 |
1.65 | 92 | 500 |
2.3 | 110 | 700 |
3.0 | 126 | 800 |
UR | A | 3.6 | 115 | 1000 | |
B | 73 | ||||
|
|
|
26
