Smeg PL115NE User instructions, E7 E8 E9, The appliance is not able to measure the, service

E7

E8

E9

	User instructions
FAULT
			DESCRIPTION
		Turbine flow-regulator malfunction
		The appliance is not able to "measure" the
		amount of water loaded accurately. Interrupt
		the program and switch off the dishwasher.
		Switch the dishwasher back on, program it
		again and start the washing cycle. If the
		problem persists, contact the after-sales
		service.
		Alternate washing system malfunction
		Interrupt the program and switch off the
		dishwasher. Switch the dishwasher back on,
		program it again and start the washing cycle. If
		the problem persists, contact the after-sales
		service.
		Water intake system malfunction
		Contact the after-sales service.
Light off		Light on	Light flashing

If an alarm occurs the appliance interrupts the program in progress and signals a fault.

•Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.

•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.

•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.

33