22 Rev 0.0
USER INSTRUCTIONS
EN
FAULT DESCRIPTION
E7
Turbine fl ow-regulator malfunction (only for models fi tted with this feature)
The appliance is unable to precisely measure the quantity of incoming water. Interrupt
the current program and switch off the dishwasher. Switch it back on again, program
a new cycle and press start. If the problem persists, contact the technical assistance
service.
E8
Alternate washing system malfunction
Interrupt the current program and switch off the dishwasher. Switch it back on again,
program a new cycle and press start. If the problem persists, contact the technical
assistance service.
E9 Water intake system malfunction
Contact the technical assistance service.
Tab. 5-01b
Alarms E1, E2, E3, E4, E8, E9 “force” the current program to the end of its
cycle.
Alarms E5, E6 interrupt the current program and, after the problem has been
eliminated, resume the cycle.
Alarm E7 is displayed at the end of the cycle which, however, is completed
given that it does not jeopardize the operation of the dishwasher.
To “reset” an alarm:
open and close the door, or switch the appliance off and back on again by
pressing the relative button (ref. 1 fi g. 5-01). At this point, the dishwasher can
be programmed again.
IF THE FAULT PERSISTS, CONTACT THE AUTHORIZED TECHNI-
CAL ASSISTANCE SERVICE.
•
•
•
•
Fig. 5-01