Instructions for the installer
8.1.2 Fixing to the electric model support structure
Create an opening in the counter top with the dimensions shown in the figure, keeping a minimum distance of 50 mm from the rear edge. The lower part of the casing must be fully accessible after the appliance has been installed.
This appliance can be mounted
against walls higher than the work surface on condition that a distance of “X” be kept between the appliance and the wall as shown in
the figure so as to avoid damage from overheating. Make sure that there is a minimum of 750 mm (Fig.
1)between the hob and any shelf that may be installed directly above it.
This type of appliance also requires milling to a depth of 3
mmon the counter top with the dimensions shown in figure 2
(detail A - The right cross section is recommended for laminated tops where the thickness is less than 3 mm). Before positioning the hob, the supplied adhesive sponge “E” (fig. 2) must be spread out over the entire surface of the milling.
32
