Smeg SE035 specifications Instructions for the Installer, Technical Information

3. INSTRUCTIONS FOR THE INSTALLER

A. TECHNICAL INFORMATION

The installation and maintenance tasks listed in this section must be performed exclusively by qualified personnel in compliance with the provisions in force.

The manufacturer cannot be held liable for any damage to objects or injury to persons resulting from the incorrect installation of the unit.

After removing the external pack and internal packaging on the mobile parts, check that the unit is complete. If you have any doubts, do not use the unit and contact your nearest Assistance Centre.

The stainless steel parts are already fitted on the unit, protected with plastic film. This protective film must absolutely be removed before using the unit.

To remove the film, you are advised to pierce it with a blade or sharp point at the edges.

Keep all packaging material (cardboard, bags, polystyrene foam, staples...) out of the reach of children, as it is a potential source of danger.

To help safeguard the environment, all packaging materials used are ecological and recyclable: the wood is not chemically treated, the boxes are 80% to 100% recycled paper, the bags are polythene (PE), the straps polypropylene (PP) and the fillers are CFC–free polystyrene foam (PS). With treatment and recycling, the raw materials can be re-used and volumes of waste reduced. Take the packaging materials back to the dealer where you bought the unit so that they can be reused. If not, take the unit to a materials disposal centre, finding out the address from your local council.

B. WARNINGS

-Note that the adhesive used to stick the laminate to the cabinet must be able to resist temperatures of at least 90°C, otherwise the lining may come unstuck.

-Note for the installer: the equipment is type X and the side walls, if any, must not be higher than the hob. Also, the rear wall and surfaces around the hob must be able to withstand an excess temperature of 75 K.

29