Instructions for the installer
8.4 Positioning of the hob
The following operation requires building and/or carpentry work so must be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as they are heat resistant (T 90°C).
Create an opening with the dimensions shown in the figure in the top surface of the counter, keeping a minimum distance of 50 mm from the rear edge.
This appliance can be mounted against walls higher than the work surface on condition that a distance of 110 mm be kept between the appliance and the wall as shown in the figure so as to avoid damage from overheating.
Make sure there is a minimum of 750 mm between the hob and any shelf that may be installed directly above it.
The dimensions indicated in the figure are the | The dimensions indicated in the figure are the |
same for all models without a frame. | same for all models with a frame. |
Below is supplied the table of comparison between the dimension Y to be created in the worktop and the dimension X of the cooker hob.
DIMENSION X | DIMENSION Y |
300 | 270 |
600 | 565 |
700 | 565 |
900 | 878 |
Below is supplied the table of comparison between the dimension K to be created in the worktop and the dimension Z of the cooker hob.
DIMENSION Z | DIMENSION K |
600 | 560 |
900 | 879 |
In case of installation on an empty kitchen unit with doors, a separation panel must be placed under the hob. Keep a minimum distance of 20 mm between the bottom of the hob and the surface of the panel, which must be easily extractable to allow sufficient access for any technical assistance.
29
