Smeg SFR30 manual Securing the Fryer

INSTALLATION

4) SECURING THE FRYER

To secure the fryer to the worktop the fastening clamps accompanying this booklet must be assembled. The following procedures must be carried out to do this:

·remove all movable parts from the fryer;

·turn the appliance over taking care to place it on a soft surface to avoid damaging the external surfaces;

·remove the clamps "G" from the package and

install them as in the diagram in fig. 6.

After these steps have been carried out, the special gasket that prevents liquids from leaking can be installed. To fit this gasket correctly, please strictly follow the directions below:

-detach the gasket strips from their support taking care that the transparent protection remains attached to the gasket;

-put the gasket "E" (fig. 6) in the correct position under the edge of the worktop, so that the outer side of the gasket fits perfectly with the external perimeter of the worktop. The ends of the strips must fit without overlapping;

-make sure the gasket adheres to the worktop evenly all around, press it down with your

fingers, then remove the gasket's protection paper and position the fryer in the opening made in the worktop;

-secure the appliance by tightening the clamp screws "F" (see fig. 7).

WARNING:

Note that the adhesive which joins the plastic laminate to the worktop must be resistant to temperatures of no less than 150°C to prevent the covering from detaching.

The installer is advised that the rear wall, adjoining and surrounding surfaces of the fryer must be resistant to a temperature of 75 K.

USEFUL MEASUREMENTS

(mm)

	A	B	C	D
FRYER	285	485	60	60

FIG. 6

FIG. 7

19