END of Cycle, Removing the Dishes | Smeg ST1144S instruction

User instructions

If the door has to be opened while washing is in progress, the program will be interrupted. The relative light will keep flashing and a beeper will signal that the cycle has not been completed. You must wait about 1 minute before closing the door to restart the program. When the door is closed the program will continue from where it was interrupted. This operation should only be carried out if strictly necessary, because it might cause problems in execution of the program.

END OF CYCLE

At the end of the washing cycle the dishwasher gives a short acustic signal and the program indicators nr 4 and 5 start blinking (the word "end" is displayed on the window).

To switch off the dishwasher, open the door and press the ON/OFF button (1).

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.

Image 11

Smeg ST1144S instruction manual END of Cycle, Removing the Dishes

Contents

Guide for Using the Dishwasher and the Washing Programs Contents Upper panel Description of the controls Program Delay Button on some models only Setting the Washing Program and Switching on 140 Changing the Program Cancelling the Current ProgramTable for Certification Bodies Reference standard Selecting Half Load Wash on some models only Washing programs Extra Programs Delaying the Program Water Hardness Table Adjusting the Water Softening SystemElectronic Setting models with display Switch Setting models without display Removing the Dishes END of Cycle Fault Description Troubleshooting Water intake system malfunction For Cleaning Dishwashers Contents Safety and operating instructions Safety instructions Safety instructions Aquastop Models Water supply connection Installation and hook-up Drain Connection Connecting to the Water SupplyElectrical connection Operating instructions Using the water softening system Using the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser Setting Adding the Detergent 1 Products General warnings and recommendations User instructions Lower Basket Using the basketsEN 50242 Standard Loads for Certification Bodies EN 50242 cycle test conditions Loading the Lower Basket Cutlery Basket Loading the Upper Basket Upper Basket Push-button version Adjusting the Upper Basket Avoid the use of acidic or abrasive detergents Cleaning and maintenanceCleaning the Water Intake Filter Cleaning the Spray Arms Prolonged Disuse Cleaning the Filter Unit Before Starting the Dishwasher After Prolonged Disuse If the dishes fail to dry or remain dull, check that 598